Finally I got round to trying the Sevy ‘packraft’, a cheapo PVC dinghy with the outer hull cut off to make it less wide and hopefully more functional.
Compared to the single-chambered Alpacka, blowing it up takes a while. The floor is made of two interlinked ribbed chambers which require a ‘spike’ beach ball inflation adapter that fits on the end of the K-Pump (right). The main chamber fills quickly enough with the K-Pump – a one-way valve ensures you get a good fill of the elastic material and it’s always a surprise to see it stay that way according to the SevyGauge™.
Even then, on the riverbank alongside the Yak it did look very small and rather low in draught so that even with a dry suit, I wasn’t convinced I wanted to get in off a steep, muddy bank. So I set off upriver to Sluice Weir in the Yak, towing the Sevy and intending to shoot the chute for a bit of fun. On the way I spotted a striking blue bird – never seen one of those before. Do you get bluebirds in Kent in mid-winter?
The Medway out of Beltring did seem a bit low compared to last summer, and as I passed under a footbridge by the weir, my heels struck a barely submerged flint-embedded concrete abutment. It was a sharp hit not the usual thud, and sure enough the Yak’s floor picked up a half inch cut. I’d been meaning to glue on some extra floor up front or better still, use a closed cell ‘heel-pad’ inside the boat. Now I’ll get round to this for sure. It’s another thing to carry/fit, but the foam will dampen the sharp hits of hard heels against a rock and spare the floor. It’s why Jeff diligently removed his shoes while paddling his slackboat on the Fitzroy last September. And it was a heel strike that led to the early demise of Steve’s soft-floored Intex on the Chassezac a few weeks before that.
I wasn’t sure if the Yak was going to fill up (it didn’t much, the floor kept the slit shut), but anyway it was high time to scoot over to the bank and try the Sevy on for size. I got in as gently as I could but it didn’t take long to have an inverted Archimedean revelation: the mass of the paddler was nearly equal to the peak buoyancy at the rear of the craft. That’s partly why Alpacka came up with the fastback tail in 2011. Unlike Archimedes, I didn’t dare jump out, put on my slippers and dressing gown, do a quick mirror-check and run across the town square yelling ‘Eureka’. I just sat still thinking ‘is it spilling over behind me and if not, why does my back feel cold?’ I took a couple of pics behind my back to establish plimsoll levels (above left), then set off slowly across the pool, with the trusty Alpacka tender bobbing along behind in case the Sevy auto-scuttled.
This was not relaxed or efficient paddling like in the Yak. I arched forward trying to offload the stern while pulling gingerly through the water for fear of initiating a possibly catastrophic water-bounce that would fill the boat. The Sevy sagged feebly under the weight of my butt and feet, just as I’d seen Jeff’s do on the Fitzroy. However Alpacka do it, it’s the rigidity in their hulls that makes them as good an airboat can be. The multiple coatings on the non-stretch fabric must have a lot to do with that. As expected the short, round Sevyslackraft yawed quite badly, even with the Alpacka in tow to act as a rudder. But that always happens first time out in one of these boats until you adopt a smoother technique. Either way, I was relieved to be wearing a drysuit.
As I bimbled around trying not to sink, the nearby weir boom opened up without warning and suddenly the Medway was kicking out a current such as it had not seen since the end of the last Ice Age. I could barely make headway in the Sev so allowed myself to be swept back to the canoe portage pier where I hopped back into the Yak. No slackage here jammed in tight, but even then, trying to get to the weir for a closer look was hard work. Within just a few minutes the river had risen 6 inches or more. I thought it had appeared rather over-full upstream in Tonbridge as I had driven through earlier. Had I arrived in the Yak about now I could have saved myself a cut floor, but of course would have had a stiff paddle getting here against the current.
Anyway, the 5-minute Sevy Slackraft trial were complete. To paraphrase Right Said Fred, I’m… Too Hefty for My Boat, although it will make a nice packraft for the Mrs who’s a little over half my weight of 95kg + winter ballast.
So, packboating newsflash: the Sevy blow up boat is not for bloaters like me. But as it’s so light I could still see a use for it as a tow barge for a bike or an extra huge payload (not that you could realistically walk with such a load). Maybe a really long river stage, or one where you want to be well equipped on arrival with a huge tent or something Anyway, there we have it, slackers. Happy New Year and continued packboating adventures to all of you!
- Semperit Forelle 2; afternoon refurb’
- Seawave sailing video
- Paddling to Brighton
- Gumotex Twist on the Tarn Gorge
- IK&P Picture of the Week
- Do you need a deck?
- Seawave Rudder MkII tested
- Inexpensive packboat rescue and survival aids
- Seawave – Oh Rudder, How Art Thou?
- Tested: Honey woodstove
- Gumotex Seawave – MYO rudder
- New Safari 330 XL and Halibut from Gumotex
- iSUP: a new way to get in trouble at sea
- 2016 Seawave with rudder option
- A quick one before lunch
- My Tweets